South Staffs Burgee
South Staffordshire Sailing Club
RYA Volvo Champion Club National Lottery - Sport England

Safety Boat Briefing

Safety Boat Briefing

 

This section outlines the responsibilities of the Safety Boat driver and crew.  It also acts as an aide-memoire for those who do not do safety boat duties very often and need a quick reminder of some of the more important aspects of the training courses.

It is not a fully comprehensive summary of our training courses.  If you would like refresher briefing or training or practice please contact Steve Finney.

During this briefing we will refer to the sailing crew.  This includes both the helm and crew of the sailing vessel.

Quick Guide:

Preparation

Always remember to check the boat and equipment before you leave the shore in line with recommendations.  More information can be found in the Powerboat Handbook.

Always check that you are suitably clothed for the conditions 

Always check that you have a working radio and can communicate with the rest of the team and the shore.

Each safety boat should have the following equipment on board:

  • Anchor
  • First Aid Kit
  • Tool Kit
  • Safety knife in place
  • Two paddles
  • Boat Hook (incorrect location)
  • Tow Ropes (three - minimun one long rope)
  • Throw bag
  • Mooring lines
  • Kill cord (in place)
  • Spare kill cord
  • Fire Extinguisher
  • Fuel Tank (with sufficient fuel for immediate needs)

Read more on Start of Day procedures. 

 

Principle Responsibilities

People before property

 

The single most important responsibility is to attend every capsize, this could be at a distance.  Do a head count and check that the sailing crew is safe and whether they are in need of further assistance.

Normally the sailing drew will right their own boat and carry on, however, until a safe situation exists, the safety boat driver and crew should monitor the situation.

If the safety boat diver and crew feels that someone is at risk (injury or hypothermia etc.) then they should be prepared to over ride the sailing crew wishes and take the crew to safety.  Abandoning a boat is NOT a risk as it is unlikely to go anywhere.

It is possible to contend with multiple issues speedily by leaving the boat to its own devices (it wil usually invert and anchor itself with the mast in the mud) and sorting out another issue.

 

Priorities

Your Safety

Safety of sailing crew rescued

Safety of other crews

Prevention of further damage to the boat or other boats

Recovery of boats

 

Even when not on duty, club members ashore should keep an eye on the water activities and be prepared to assist when necessary.  That can be to launch another Saftey boat, ring for an ambulance, prepare first aid kit, advise safety boat of capsize that they may not be aware of.

Kill cord

ALWAYS wear the kill cord at ALL times.

A kill cord is coiled in its design to allow the driver the natural movement required when helming a boat.  Should the driver move away from, or be thrown from, the helm position the kill cord will detach from the console and the engine will stop.  Detaching the kill cord also allows a crew or passenger to stop the engine if the driver were to become incapacitated whilst at the helm e.g. they fainted.

   

The results of the 2015 RYA survey investigating the causes of kill cord and kill switch failure has recently been published: Read more survey information.  One particular item was storing of kill cords in position and the reliability of the switch over time when this is done.

We have a club recommendation to check the kill cord action every time the boats are used.  The club now have a key board on the wall near the entry door of the boat shed.  It is the club's recommendation that at the end of each use, the ignition keys and kill cords be stored on the board.  The hooks are numbered to match the boats and if they get mixed, the big Honda engine on RIB One has a Honda Marine key ring, the engine on RIB Three is a Suzuki and this is on the key, the little Jeanneau, (little Honda engine) does not have an ignition switch and only a kill cord.

 

Back to top of the page

Basic Manoeuvres

These guidelines give an overview of options available, they are not intended to be exclusive.  Creativity may sometimes be needed to accomplish them safely.  

Leaving the Jetty - Windward

  • RIB - Go off in reverse or use big sideways push and go ahead QUICKLY
  • Go bow into jetty to swing transom out, reverse out and go ahead when clear
  • Pilot -Big push sideways and get way on before it blows back
  • Go straight ahead when leaving the jetty

Leaving the Jetty - Leeward

  • Cast off and reverse away before going ahead
  • Cast off and drift down wind before going ahead
  • Beware of the transom when getting under way

Arriving at the Jetty

  • Approach at a shallow angle then:

Option One - Reverse engine and apply full opposite lock to finally stop boat and bring transom in.

Option Two - Come in slowly and do not sue reverse.  Small amount of lock will swing transom in.

MOOR FORE AND AFT

Further details can be found in the Power Boat Handbook - start and end of day procedures - found on our members web pages. 

 

Rescuing/Giving Assistance

People in the water.  

The engine should be switched OFF when getting someone into the boat unless to do so could put the safety boat in danger e.g. close to lee shore.

The best line of approach is from down wind to allow better speed control against the wind.  Recover people either face in to side of boat and lift, or roll them onto the boat.  Ladders are fitted to the boats and a tow rope with a loop in it for the casulty to stand in, often works.

                                           

If a person is in distress:

  • Get them to shore quickly
  • Keep them out of the wind (Generated by the speed of the boat)
  • Do not give them HOT drinks or Alcohol
  • No artificial heat.

Dinghy rescue

If the crew are OK just standing by may be sufficient.

Dinghy has inverted and mask is stuck in the mud.  It is almost inevitable that modern dinghies will try to invert.  This will result with the mast stuck in the mud unless they are near mark 7 where it is deep enough to turn turtle.

If the sailing crew has got the boat level, you can help by pulling the bows of the capsize boat into the wind by pulling on the forestay at the stern head fitting.  This will ensure that they come upright into the wind.  Keep moving gently into the wind even when the capsized boat is upright as this will keep the boats stable and head to wind.

 

        

If the mask has got stuck in the mud, you can tie a rope arond the shroud and pull in line with the mast until the boat come level and then head to the bow to keep it under control.

Rembmber that you can help to keep the boat level by moving gently into the wind, as the sails will act as a wing and rise to the surface.

If the crew needs help to get the boat upright from this horizontal position, pull upwards on the forestay.  You will need to be near the spreader level to get enough leverage as the boat comes up you will need to move down the forestay quickly to maintain contact with the boat.

Remember you are likely to get wet and if you don't move your hand position down you could take off !

                                                        

Sometimes you can help the recovery situation by rotating the capsize craft so that its bows are nearly into the wind.  You can rotate the boat from either the bows or mast head.  Beware inverting the burgee if operating from the mast head.  For some reason this annoys the boat owner.  Smile

Back to the top of the page

Towing

Alongside:  You should have in place a bow line, stern line and 2 springs running fore and after to take the loads.

Practicality dectates that this ideal option may not be optimal, so select the number of ropes that you need depending on conditions.  If winds are light (such as assisting craft home on a windless Tuesday night) holding onto the shrouds may suffice.  Ask the helm to push the plate up and steer to follow you.

Remember that the engine of the safety boat needs to be astern of the towed boat to give reasonable manoeuvrability when towing.  Boats should be 'Toed in' if possible.

Astern:  Take tow rope around forestay and then around the mast and get the helm to hold on.

DO NOT MAKE FAST ON TO TOWED BOAT

For OK dinghies it may be necessary to make a bow loop from their painter.  If this is not practical, use the tow rope only round the mast BUT BE VERY CAREFUL AS YOU COULD FLIP THE TOWED BOAT.

At tow boat end use the bridle to keep the rope clear of the engine.  Don't make fast unless absolutely necesary.  Ask dinghy helm to push the plate almost up and steer to follow you.

 

Final Thoughts

In addition to hypothermia, Dehydration is a very high risk to dinghy sailors.

Signs and symptoms include:

  • Headache
  • Tiredness
  • Dizziness
  • Confusion
  • Nausea
  • Pale skin, perhaps masked by exposure to sun and wind
  • Stopping sweating is a sign of serious deterioration
  • Thirst, or lack of thirst, should NOT be seen as a good sign of condition

Back to top of page

                  

 

March 2016